Switching

IMPORTANT MODERATION NOTICE

This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.



  • 1.  EX-4600 unconnected uplink interface showing error.

    Posted 24 days ago
    Hi Team,

    I have implemented a ex-4600 (2vc) as distribution. The unconnected uplink interface et-0/0/24 (i.e without sfp) showing following error messages for every second. Due which it is increasing the cpu utilization presently 77%

    fpc0 : dcbcm_drv_port_get_link_status: Port Phy control get failed for port 24 error Feature unavailable

    fpc1 : dcbcm_drv_port_get_link_status: Port Phy control get failed for port 24 error Feature unavailable



    ------------------------------
    NAVEEN M
    ------------------------------


  • 2.  RE: EX-4600 unconnected uplink interface showing error.

     
    Posted 23 days ago
    Hi Naveen,

    Port 24 refers to the BCM port and not the front panel port.

    Please check if you have any port configured as VCP but unused/down and delete them.

    switch> show virtual-chassis vc-port




  • 3.  RE: EX-4600 unconnected uplink interface showing error.

    Posted 21 days ago
    HI Avishm,

    I have disabled the et-0/0/24 and et-1/0/24.But receiving same log messages.

    lab@MRV-AS-R03-DS-01# show virtual-chassis status
    Preprovisioned Virtual Chassis
    Virtual Chassis ID: aa9a.93a8.8422
    Virtual Chassis Mode: Enabled
    Mstr Mixed Route Neighbor List
    Member ID    Status                   Serial No                 Model             prio              Role         Mode   Mode ID          Interface
    0 (FPC 0)           Prsnt         TC3721160238      ex4600-40f      129      Master* N        VC           1             vcp-255/0/22
                                                                                                                                                                                                     1             vcp-255/0/23
    1 (FPC 1)           Prsnt         TC3721160449       ex4600-40f     129        Backup N         VC          0             vcp-255/0/22
                                                                                                                                                                                                     0              vcp-255/0/23

    ------------------------------
    NAVEEN M
    ------------------------------



  • 4.  RE: EX-4600 unconnected uplink interface showing error.

     
    Posted 20 days ago
    Hi Naveen,

    As I mentioned, Port 24 in the log message is NOT the front panel port et-0/0/24 and et-1/0/24.

    Please share output of below command:

    switch> show virtual-chassis vc-port