Hi All,
I've recently started with Juniper.
I've read through the document for MVRP:
It seems to be what I'm looking for but I can't get the access switches to give the vlan's to the distribution switch.
I have a cable from the dist switch directly to the access switch. Both ends are trunks.
TRUNK PORT BELOW SAME ON BOTH ENDSxe-0/0/20 {
unit 0 {
family ethernet-switching {
interface-mode trunk;
vlan {
members all;
mvrp {
}
interface xe-0/0/22;
But I get no vlan's and the stats are below:
MVRP statistics for routing instance 'default-switch'
Interface name : xe-0/0/22
VLAN IDs registered : 0
Sent MVRP PDUs : 238
Received MVRP PDUs without error: 217
Received MVRP PDUs with error : 0
Transmitted Join Empty : 0
Transmitted Leave All : 86
Recieved Join In : 0
Transmitted Join In : 0
Transmitted Empty : 1685
Transmitted Leave : 0
Transmitted In : 0
Transmitted New : 0
Received Leave All : 74
Received Leave : 0
Received In : 0
Received Empty : 899
Received Join Empty : 0
Received New : 0
Any help appreciated.
Thanks
SAM
Multiple VLAN Registration Protocol
Juniper |
remove preview |
|
Multiple VLAN Registration Protocol |
Multiple VLAN Registration Protocol (MVRP) is a Layer 2 messaging protocol that automates the creation and management of virtual LANs, thereby reducing the time you have to spend on these tasks. Use MVRP on Juniper Networks switches to dynamically register and unregister active VLANs on trunk interfaces. |
View this on Juniper > |
|
|
------------------------------
SAM WHARTON
------------------------------