Switching

I'm installing a new set of QFX5100s and am having difficulty with the vme management interface. I have two QFX5100s in a VC pair, and have C0 (em0) on each QFX5100 connected to our management network. Very minimal config on the QFXs, and we're at least initially not doing any layer-3 on them.

admin@dcas01a-ts1dc> show interfaces terse vme     
Interface               Admin Link Proto    Local                 Remote
vme                     up    down
vme.0                   up    down inet     10.38.4.87/24    

{master:0}
admin@dcas01a-ts1dc> show interfaces terse em0  
Interface               Admin Link Proto    Local                 Remote
em0                     up    up
em0.0                   up    up   

{master:0}

Hi Stafford

Please check em0.0 is configured on the switches in the VC and If configured delete the em0.0 from the switches and configure vme0.0 only on the master switch and check  the reachability.

em0 port status should be "UP UP" on the switches.

Thanks,

Arul

That did the trick! I thought I had already tried that, but it seems not. Many thanks!

admin@dcas01a-ts1dc> show interfaces vme terse  
Interface               Admin Link Proto    Local                 Remote
vme                     up    up
vme.0                   up    up   inet     10.38.4.88/24