Switching

 View Only

IMPORTANT MODERATION NOTICE

This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.



  • 1.  Auto Image Upgrade

    Posted 09-14-2018 13:28

    I completed an update to the firmware to 15.1X53-D59 via usb and now I keep getting recurring message: 

     

    Auto Image Upgrade: DHCP Client Bound interfaces:

    Auto Image Upgrade: DHCP Client Unbound interfaces:

    Auto Image Upgrade: To stop, on CLI apply
    "delete chassis auto-image-upgrade" and commit

    Auto Image Upgrade: No DHCP Client in bound state, reset all DHCP clients

    Auto Image Upgrade: DHCP Client State Reset:

     

    I am at this time trying to also update the J-web though the interface and its not accepting the update i beleve it's because of above Any tips would be gratly apprecated. It's a Ex3400 POE



  • 2.  RE: Auto Image Upgrade

     
    Posted 09-14-2018 16:59

    Just go into the CLI and while the messages are spewing out type:

     

    delete chassis auto-image-upgrade

    commit

     

    and then move forward.



  • 3.  RE: Auto Image Upgrade

    Posted 09-14-2018 18:18

    sounds simple enough but i get: 

     

    {master:0}[edit]
    root@demoroom# delete chassis auto-image-upgrade
    delete chassis auto-image-upgrade
    warning: statement not found

    {master:0}[edit]
    root@demoroom#

     

    or : 

    unknown command.
    root@demoroom> deletechassisauto-image-upgrade
    ^
    unknown command.

    {master:0}
    root@demoroom>

     



  • 4.  RE: Auto Image Upgrade

    Posted 09-17-2018 04:45

    I was able to get rid of this finally but it seem to go away after I finished the ezsetup only. thenks for your  help. 



  • 5.  RE: Auto Image Upgrade

    Posted 11-05-2018 05:50

    I am getting the same errors, however, I cannot seem to do the EZSetup either. I am getting a "Command Not Found" each time.



  • 6.  RE: Auto Image Upgrade

    Posted 11-12-2021 05:36
    It worked for me on a 96-port QFX510 switch
    Thanks

    ------------------------------
    OCTAVIO CASTILLO
    ------------------------------