Switching

Expand all | Collapse all

Auto Image Upgrade

  • 1.  Auto Image Upgrade

    Posted 09-14-2018 13:28

    I completed an update to the firmware to 15.1X53-D59 via usb and now I keep getting recurring message: 

     

    Auto Image Upgrade: DHCP Client Bound interfaces:

    Auto Image Upgrade: DHCP Client Unbound interfaces:

    Auto Image Upgrade: To stop, on CLI apply
    "delete chassis auto-image-upgrade" and commit

    Auto Image Upgrade: No DHCP Client in bound state, reset all DHCP clients

    Auto Image Upgrade: DHCP Client State Reset:

     

    I am at this time trying to also update the J-web though the interface and its not accepting the update i beleve it's because of above Any tips would be gratly apprecated. It's a Ex3400 POE



  • 2.  RE: Auto Image Upgrade

     
    Posted 09-14-2018 16:59

    Just go into the CLI and while the messages are spewing out type:

     

    delete chassis auto-image-upgrade

    commit

     

    and then move forward.



  • 3.  RE: Auto Image Upgrade

    Posted 09-14-2018 18:18

    sounds simple enough but i get: 

     

    {master:0}[edit]
    root@demoroom# delete chassis auto-image-upgrade
    delete chassis auto-image-upgrade
    warning: statement not found

    {master:0}[edit]
    root@demoroom#

     

    or : 

    unknown command.
    root@demoroom> deletechassisauto-image-upgrade
    ^
    unknown command.

    {master:0}
    root@demoroom>

     



  • 4.  RE: Auto Image Upgrade

    Posted 09-17-2018 04:45

    I was able to get rid of this finally but it seem to go away after I finished the ezsetup only. thenks for your  help. 



  • 5.  RE: Auto Image Upgrade

    Posted 11-05-2018 05:50

    I am getting the same errors, however, I cannot seem to do the EZSetup either. I am getting a "Command Not Found" each time.