Ok, so I enabled the Telnet service and configured fxp0 with an IP address the same as the one assigned in the network adapter, what should i do next?
I also remember setting the interface ge-0/0/0 in the trust zone but didn't know what the configuration should be in terms of addressing
------------------------------
AHMAD ADEL
------------------------------
Original Message:
Sent: 04-16-2021 02:46
From: Ulf Bremer
Subject: Telneting vSRX
It would be very helpful if you could share the steps you've tried, so we can figure out from there what might have went wrong.
In general you'd need to: 1. enable system services telnet (but perferably ssh) 2. configure an IP address on interfaces fxp0.0 family inet 3. in vmware connect the vSRX first NIC to a network shared with the vm from which you want to establish the connection
Original Message:
Sent: 04-15-2021 19:35
From: AHMAD ADEL
Subject: Telneting vSRX
Hello,
I'm running vSRX on VMware and I'm trying to telnet via command prompt cause i can't scroll up in VMware to look through few pages of output.
So, i tried some steps i found on google but i can't seem to get it work..
------------------------------
AHMAD ADEL
------------------------------