Skip to main content (Press Enter).
Skip auxiliary navigation (Press Enter).
Terms and Conditions
Skip main navigation (Press Enter).
on this day
between these dates
Ideas & Innovation
Rise with Us
Become A Member
Back to discussions
VLAN to MX
VLAN to MX
Posted 02-12-2021 02:58
I am trying to configure the following:
Customer A / Customer B --> ge-0/0/0/ge-0/0/3 SRX ge-0/0/5 --> MX ge-0/0/5 (Routing will take place at this point).
So, the SRX is NTE for Customers but only we manage it so, from a customers perspective the Gateway for them will be on the MX making the SRX Transparent. But I configure up an irb interface for the management from the MX to the SRX. Here are the VLANs
VLAN 10 - Customer-A
VLAN 20 - Customer-B
VLAN 99 - Management
When configuring Q-in-Q I can configure the MX interface as follows and all works fine:
set interfaces ge-0/0/5 unit 10 description Customer-A
set interfaces ge-0/0/5 unit 10 vlan-tags outer 300
set interfaces ge-0/0/5 unit 10 vlan-tags inner 10
set interfaces ge-0/0/5 unit 10 ip address 172.16.16.2/30
set interfaces ge-0/0/5 unit 99 description NTE-Management
set interfaces ge-0/0/5 unit 99 vlan-tags outer 500
set interfaces ge-0/0/5 unit 99 vlan-tags inner 99
set interfaces ge-0/0/5 unit 99 family inet address 192.168.99.2/30 - opposing NTE IRB Interface will be addressed as 192.168.99.1/30
set interfaces ge-0/0/5 unit 20 description Customer-B
set interfaces ge-0/0/5 unit 20 vlan-tags outer 300
set interfaces ge-0/0/5 unit 20 vlan-tags inner 10
set interfaces ge-0/0/5 unit 20 ip address 10.10.10.2/30
However, I do not have a downstream ISP in between now and therefore cannot strip an S-Tag so I need to make the MX Interface capable of receiving multiple VLANs (Trunked) and be routed directly from the MX and I cannot get that working. Any ideas anyone?
New Best Answer
This thread already has a best answer. Would you like to mark this message as the new best answer?
Copyright � 2020 Answers | Elevate Community | Juniper Networks. All rights reserved.
Powered by Higher Logic