SRX

Expand all | Collapse all

Static routes with RPM

Jump to Best Answer
  • 1.  Static routes with RPM

    Posted 12-03-2017 07:46

    Hi everyone,

    This is I am trying to accomplish:

     

    SRX f1-199.199.199.1/30-( PROVIDER A SWITCHED NETWORK)-199.199.199.2/30 PE

           f2-200.200.200.1/30-(PROVIDER B SWITCHED NETWORK)-200.200.200.2/30 PE

    We are using Static routes on SRX:

     

    0/0 next -hop 199.199.199.2 

    0/0 next-hop 200.200.200.2 Route preferrence 10

     

    We have control only over SRX, our issue is since SRX is not directly connected to PE, therefore any break within Switched Newtork of Providers will blackhole our traffics.

     

    This is what I am thinking:

    ( I do not want to use Filter based Forwarding with RPM  to keep the design simple and intutive)

    1) Define RPM and then tie RPM to STATIC routes, so if RPM fails, STATIC route is removed from routing table.

    I can use the link to set up desired RPM but I am trying to figure out how to associate RPM with static routes.

     

    https://kb.juniper.net/InfoCenter/index?page=content&id=KB25052

     

    Thanks and have a nice weekend!!

     

     

     



  • 2.  RE: Static routes with RPM
    Best Answer



  • 3.  RE: Static routes with RPM

     
    Posted 12-23-2017 08:49

    Hi Folks,

    Junos Security: A Guide to Junos for the SRX Services Gateways and Security Certification is a good book covering such use cases

     

    https://www.amazon.com/Junos-Security-Services-Gateways-Certification-ebook/dp/B0043D2E1S