Management

What should I do if I do not see any data in the monitor and fault modes?

By Elevate posted 02-28-2016 21:32

  

Question

What should I do if I do not see any data in the monitor and fault modes?

Answer

If you face such a scenario, you must restart the jboss service that runs in Junos Space to stop and start the jboss service:

  1. Log in to the Junos Space system console.
  2. When the console displays the Junos Space Appliance Settings menu, enter the number corresponding to the run shell option at the prompt.
  3. Type the password and press Enter.
  4. At the shell prompt, type the following commands sequentially and press enter after each command:
[root@space]#service jmp-watchdog stop
[root@space]#service jboss stop
[root@space]#service jboss start
[root@space]#service jmp-watchdog start

Junos Space restarts. This might take a few minutes. After Junos Space restarts, you can log in to Network Director and continue working in Monitor and Fault modes.

 

You can learn more about the monitor mode in Network Director from the Network Director documentation or the online Help.


#JunosSecure
#monitormode
#FAQ
#faultmode
#JunosSpaceNetworkDirector
#jboss
0 comments
0 views

Permalink